BS10 TABLE E FLANGE Manufacturers china tells you that the flat welding flange with the neck is connected to the pipe end, and it is mainly a part that connects the pipe to the pipe. BS10 TABLE E FLANGE Manufacturers china tells you that there are holes in the flat welding flange with the neck, through which bolts can pass through, so that the two flanges are tightly connected, and the flanges are sealed with gaskets. The neck flat welding flange connection refers to a pair of flanges, a gasket and a number of bolts and nuts.

BS10 TABLE E FLANGE Manufacturers china tells you that its gasket is placed between the sealing surfaces of the two flanges. After the nut is tightened, the specific pressure on the surface of the gasket reaches a certain value and then deforms, and fills up the unevenness on the sealing surface. , so that the connection is tight. A flange connection is a detachable connection. According to the connected parts, it can be divided into a container flange and a pipe flange. Slip-on neck flanges are suitable for steel pipe connections with a nominal pressure not exceeding 2.5MPa.
BS10 TABLE E FLANGE Manufacturers china tells you that a flat welding flange with the neck is used for butt welding between the flange and pipe. It has reasonable structure, high strength, and rigidity, can withstand high temperature and high pressure, repeated bending and temperature fluctuation, and has reliable sealing. The neck flat welding flange with a nominal pressure of 0.25-2.5MPa adopts a concave-convex sealing surface.
Through the above introduction and analysis of the BS10 TABLE E FLANGE Manufacturers china, hope it helps you.